LMX Error Messages, Non-Critical

The following table contains LMX error messages that may appear during run-time. Refer to Running Scripts for Engineering Support Analysis for information on gathering information about systems and configurations for VERITAS support personnel.

If the display of these messages creates errors while running an Oracle application, use the lmxconfig command to turn off the display. For example:

# /sbin/lmxconfig -e 0

To re-enable the display of the messages, type:

# /sbin/lmxconfig -e 1

Message ID	LMX Message
06001	lmxreqlink duplicate kreq= 0xaddress, req= 0xaddress
06002	lmxreqlink duplicate ureq= 0xaddress kr1= 0xaddress, kr2= 0xaddress req type = number
06003	lmxrequnlink not found kreq= 0xaddress from= number
06004	lmxrequnlink_l not found kreq= 0xaddress from= number
06101	lmxpollreq not in doneq CONN kreq= 0xaddress
06201	lmxnewcontext lltinit fail err= number
06202	lmxnewcontext lltregister fail err= number
06301	lmxrecvport port not found unode= number node= number ctx= number
06302	lmxrecvport port not found (no port) ctx= number
06303	lmxrecvport port not found ugen= number gen= number ctx= number
06304	lmxrecvport dup request detected
06401	lmxinitport out of ports
06501	lmxsendport lltsend node= number err= number
06601	lmxinitbuf out of buffers
06602	lmxinitbuf fail ctx= number ret= number
06701	lmxsendbuf lltsend node= number err= number
06801	lmxconfig insufficient privilege, uid= number
06901	lmxlltnodestat: LLT getnodeinfo failed err= number


^ Return to Top	< Previous \| Next >

Product: Storage Foundation for Oracle RAC Guides
Manual: Storage Foundation 4.1 for Oracle RAC Installation and Configuration
VERITAS Software Corporation www.veritas.com