Administering Clusters

  To add a system to a cluster

This section provides an overview of tasks involved in adding a node to a cluster. For detailed instructions, see the VERITAS Cluster Server Installation Guide.

1. Make sure the system meets the hardware and software requirements for VCS. See the VERITAS Cluster Server Installation Guide for details.
2. Set up the private communication links from the new system.
3. Install VCS and require patches on the new system.
4. Add the VCS license key. See Installing a VCS License for instructions.
5. Configure LLT and GAB to include the new system in the cluster membership.
6. Add the new system using the hasys -add command.

  To remove a node from a cluster

This section provides an overview of tasks involved in adding a node to a cluster. For detailed instructions, see the VERITAS Cluster Server Installation Guide.

1. Make a backup copy of the current configuration file, main.cf.
2. Switch or remove any VCS service groups from the node. The node cannot be removed as long as it runs service groups on which other service groups depend.
3. Stop VCS on the node.
   # hastop -sys systemname
4. Delete the system from the SystemList of all service groups.
   # hagrp -modify groupname SystemList -delete systemname
5. Delete the node from the cluster.
   # hasys -delete systemname
6. Remove the entries for the node from the following files on each remaining node:
   • /etc/gabtab
   • /etc/llthosts

7. Unconfigure GAB and LLT on the node leaving the cluster.
8. Remove VCS and other packages from the node.
9. Remove GAB and LLT configuration files from the node.

  To modify a cluster attribute