DbEnv.set_verbose

import com.sleepycat.db.*; public int set_verbose(u_int32_t which, boolean onoff); Description The DbEnv.set_verbose method turns additional informational and debugging messages in the Berkeley DB message output on and off. If onoff is set to true, the additional messages are output. The which parameter must be set to one of the following values: Db.DB_VERB_CHKPOINT Display checkpoint location information when searching the log for checkpoints. Db.DB_VERB_DEADLOCK Display additional information when doing deadlock detection. Db.DB_VERB_RECOVERY Display additional information when performing recovery. Db.DB_VERB_WAITSFOR Display the waits-for table when doing deadlock detection. The DbEnv.set_verbose interface may be used to configure Berkeley DB at any time during the life of the application. The DbEnv.set_verbose method throws an exception that encapsulates a non-zero error value on failure. The environment's verbosity may also be set using the environment's DB_CONFIG file. The syntax of the entry in that file is a single line with the string "set_verbose", one or more whitespace characters, and the interface which argument as a string, for example, "set_verbose DB_VERB_CHKPOINT". Configuration in the DB_CONFIG file silently overrules configuration done using the DbEnv.set_verbose method. Errors EINVAL An invalid flag value or parameter was specified. Class DbEnv See Also DbEnv.close, DbEnv.open, DbEnv.remove, DbEnv.strerror, DbEnv.get_version_string DbEnv.set_cachesize, DbEnv.set_errcall, DbEnv.set_error_stream, DbEnv.set_errpfx, and DbEnv.set_verbose.