| Variable
|
Definition and Default Value
|
|---|
VCS_CONF
|
Root directory for VCS configuration files.
Default: /etc/VRTSvcs
Note If this variable is added or modified you must reboot the system to apply the changes.
|
VCS_ENABLE_LDF
|
Designates whether or not log data files (LDFs) are generated. If set to 1, LDFs are generated. If set to 0, they are not.
|
VCS_HOME
|
Root directory for VCS executables.
Default: /opt/VRTSvcs
|
VCS_HOST
|
VCS node on which ha commands will be run.
|
VCS_GAB_PORT
|
GAB port to which VCS connects.
Default: h
|
VCS_GAB_TIMEOUT
|
Timeout in milliseconds for HAD to send heartbeats to GAB.
Default: 15000
Note If the specified timeout is exceeded, GAB kills HAD, and all active service groups on system are disabled.
|
VCS_HAD_RESTART_TIMEOUT
|
Set this variable to designate the amount of time the hashadow process waits (sleep time) before restarting HAD.
Default: 0
|
VCS_LOG
|
Root directory for log files and temporary files.
Default: /var/VRTSvcs
Note If this variable is added or modified you must reboot the system to apply the changes.
|
VCS_SERVICE
|
Name of configured VCS service.
Default: vcs
Note The specified service should be configured before starting the VCS engine (HAD). If a service is not specified, the VCS engine starts with port 14141.
|
VCS_TEMP_DIR
|
Directory in which temporary information required by, or generated by, hacf is stored.
Default: /var/VRTSvcs
Note This directory is created in /tmp under the following conditions:
- The variable is not set.
- The variable is set but the directory to which it is set does not exist.
- The utility hacf cannot find the default location.
|
