Viewing RLINK Information
Use the RVG views to view information about the RLINKs. The RLINKs section in Primary and Secondary RVG views displays information about the RLINKs in the Primary and Secondary RVG respectively.
RLINK Information
The RVG view initially displays the following information about the RLINKs in the selected RVG:
Name
|
Name of the RLINK.
|
State
|
State of the connection (RLINK) between the Primary and the Secondary.
|
Flags
|
Displays ATTACHED when the Primary and the Secondary are attached; displays DETACHED if the Primary and Secondary are not attached. Other flags such as ENABLED, DISABLED, CONSISTENT, INCONSISTENT, CANT_SYNC, CONNECTED, DISCONNECTED also display in this column. For the meaning of these flags, see the VERITAS Volume Replicator Administrator's Guide.
|
Protocol
|
Transport protocol being used for replication.
|
Bandwidth Limit
|
Shows the bandwidth limit for VVR if specified, or none.
|
Replication IP
|
Shows the host name used for replication by the RLINK, with the IP address in parenthesis.
|
Viewing Detailed RLINK Information
A (+) icon is available for each displayed RLINK. The view can be expanded to show detailed information for the RLINK.
To expand the view and display information about the attributes of the RLINK
- Click the (+) icon near the RLINK name. The (+) icon changes to a minus (-) icon.
The expanded view shows the following information:
- Replication settings of the RLINK
- Information about the Remote RLINK
To collapse the expanded view
Replication Settings of the RLINK
The expanded view displays the following information about the attributes of the selected RLINK:
Replication Mode
|
Displays synchronous or asynchronous.
|
SRL Protection
|
Displays autodcm, dcm, override, off, or fail.
|
Latency Protection
|
Displays override, off, or fail depending on the chosen option.
|
Latency Low Mark
|
Number of updates in the SRL before the protection becomes inactive and updates succeed.
|
Latency High Mark
|
Specifies the maximum number of waiting updates in the SRL before the protection becomes active and updates stall or fail.
|
Information About the Remote RLINK
The expanded view displays the following information about the remote RLINK:
Replication IP
|
Name of the remote host and IP in parenthesis.
|
Name
|
Name of the remote RLINK.
|
Protocol
|
Transport protocol being used for replication.
|
Bandwidth Limit
|
Shows the bandwidth limit for VVR if specified, or none.
|
To expand the view and display more information for the remote RLINK
- Click the (+) icon for the remote RLINK. The (+) icon changes to a minus (-) icon.
The expanded view shows the replication settings for the remote RLINK.
To collapse the expanded view
|
