REPLACE SCRIPT

Syntax

replaceScript::=

Description of the illustration replacescript.gif

Purpose

To replace an existing script stored in the recovery catalog. If the script does not exist, then REPLACE SCRIPT creates it.

A stored script is a sequence of RMAN commands, given a name and stored in the recovery catalog for later execution. A stored script may be local (that is, associated with one target database) or global (available for use with any database registered in the recovery catalog).

For more information about stored scripts and commands used to create, update, delete and execute stored scripts, see "CREATE SCRIPT".

Restrictions and Usage Notes

Execute REPLACE SCRIPT only at the RMAN prompt.
You must be connected to a target database and recovery catalog. If you are replacing a local script, then you must be connected to the target database that you connected to when you created the script.
When using REPLACE SCRIPT, RMAN must be connected to a recovery catalog, and the catalog database must be open.
If no script by the specified name exists, one will be created.
The @ and @@commands do not work within REPLACE SCRIPT.

Keywords and Parameters

Syntax Element	Description
`GLOBAL`	Restricts RMAN to replacing or creating a global stored script, instead of a local one. If omitted, RMAN looks for a local stored script `script_name` defined on the current target database. If one is found, RMAN updates the local script with the new script contents. If no local script is found, RMAN looks for a global stored script `script_name`. If a global script `script_name` is found, RMAN updates it with the new script contents.
`'script_name'`	Identifies the local or global script being replaced.
`COMMENT ='comment'`	An explanatory comment, used in the output of LIST SCRIPT NAMES..
`FROM FILE` `'filename'`	The new contents of the script are to be read from this file. The first line of the file must begin with a "`{`", the last line must contain a "`}`" and the commands must be valid within a RUN block.
`{` `backupCommands` \| `maintenanceCommands` \| `miscellaneousCommands` \| `restoreCommands` }	Commands valid in a stored script. These are the same commands supported within a RUN block. See "RUN" for more details about `backupCommands, restoreCommands, maintenanceCommands, and miscellaneousCommands`.

Example

Replacing a Recovery Catalog Script: Example This example updates a stored script called backup_full:

REPLACE SCRIPT backup_full 
COMMENT 'Run this to back up the database'
{
   # uses configured channel for default device type
   BACKUP DATABASE;
}

If there is a local script backup_full, it is updated. If there is no local script backup_full but there is a global script backup_full, the global script is updated.