ALTER_CATCHUP_PARAMETERS Procedure
This procedure alters the values for the following parameters stored in the DBA_REPEXTENSIONS
data dictionary view:
percentage_for_catchup_mdef
cycle_seconds_mdef
percentage_for_catchup_new
cycle_seconds_new
These parameters were originally set by the ADD_NEW_MASTERS
procedure. The new values you specify for these parameters are used during the remaining steps in the process of adding new master sites to a master group. These changes are only to the site at which it is executed. Therefore, it must be executed at each master site, including the master definition site, if you want to alter parameters at all sites.
Syntax
DBMS_REPCAT.ALTER_CATCHUP_PARAMETERS (
extension_id IN RAW,
percentage_for_catchup_mdef IN BINARY_INTEGER := NULL,
cycle_seconds_mdef IN BINARY_INTEGER := NULL,
percentage_for_catchup_new IN BINARY_INTEGER := NULL,
cycle_seconds_new IN BINARY_INTEGER := NULL);
Parameters
Table 18-15 ALTER_CATCHUP_PARAMETERS Procedure Parameters
Exceptions
Table 18-16 ALTER_CATCHUP_PARAMETERS Procedure Exceptions